Skip to content
Timber stairs, made for your project03 9720 7266
LOSP pine stair-kit stringers and treads before assembly

Reference photograph. Confirm the material, profile and components in your specific quote.

Plan your stair project

Timber stringers

Enquire about timber stringers for a new flight or a retained tread assembly. State which components and positions need to remain.

No online payment. Send a quote request and we will confirm the specification and price.

Width is for the enquiry; available sizes and any support requirements are confirmed before supply.

What should I measure?

Describe the stringers required, the flight geometry and retained tread positions. Mark the upper and lower ends, housings and support locations on a sketch. Keep full stringer length separate from horizontal projection.

Does the calculator confirm compliance?

No. The calculator is an indicative geometry tool. Final design, structural support, landings, headroom, handrails, barriers and slip resistance require project-specific checks.

Timber stair stringers for a measured flight

Stringers support the treads. A stringer-only enquiry is different from a complete kit: list any treads, centre supports and fixings needed separately. Replacing a stringer also requires checking the existing tread section, housings and connections.

Prepare your stringer enquiry

  • State the required quantity and whether you want individual members or a pair quoted.
  • Show the flight geometry, width definition, support locations and any tread housings or connections that must remain.
  • List treads, fixings or other parts separately when you need them included in the enquiry.

Check inclusions, ordering and delivery questions or use the printable measurement sheet. Sending a quote request does not place an order or take payment.

Review the final specification, price, timing and freight before ordering. Ask for the instructions for the actual supplied kit and use the installation planning guide to prepare the site questions.

Keeping existing treads or housings?

Mark which tread positions and housing details must remain, and which parts you intend to replace. Ask the supplier to compare the proposed stringers with that retained arrangement rather than assuming a new tread count can use the same housings.

On a sketch, distinguish the full stringer length from the locations where it is supported. Mark the upper and lower ends; do not substitute the horizontal projection for a component length. Send these details with your stringer enquiry.

Check the shape before the quote.

Use the free stair calculator to explore risers, treads and projection.

Open stair calculator ↗

Practical stair planning

Good stairs start with good information.

All stair guides →

Make the next step yours

Start with your measurements.

Add a stair to your quote, or talk through what you need with us.

Build your quote